Horario de atención y direcciones de las tiendas

Epoxy Resins

Epocoat GREY -Gel Coat epoxi-

Epocoat GREY -Gel Coat epoxi-

Gel Coat Epoxy gray.
Thixotropic and high resistance to abrasion.
Ideal for FX molds and precision molds.

More details...

Kit de 920gr.

25,00 €

tax excl.
30,25 € (tax incl.)

Add to wishlist

You must be logged

EpoxAcoat® GREY is a thixotropic epoxy gel coat which is widely used for hand laminating/ tooling applications. Its tough and strong surface coat resins which cure at room temperature offer exceptional abrasion resistance.

EpoxAcoat® GREY is easy to use, wet out well over a variety of surfaces and will coat vertical surfaces without sagging. After the epoxy becomes “tacky-hard” at room temperature, fiberglass cloth is laminated behind the surface coat using Free Form® AIR putty or EpoxAmite® Laminating Epoxy to produce strong, lightweight tools that have excellent dimensional stability and surface finish. Cured surface machines precisely without chipping. Applications include precision tooling, master and pattern making, core boxes and fixtures.

Preparation – Avoid breathing fumes - use in a well ventilated area at minimum. NIOSH approved respirator is recommended. Wear safety glasses, long sleeves and rubber gloves to minimize skin contact. This material has a high exotherm (generates heat). Do not mix components in glass or foam containers.

Materials should be stored and used in a room temperature environment (73°F/23°C). Elevated temperatures will reduce Pot Life.

Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.

Applying A Release Agent – For releasing epoxy from non-porous surfaces such as resin, metal, glass etc., use Ease Release 200 or 205 (available from Smooth-On) to prevent adhesion.

Measuring / Dispensing – Accurate ratio measurements by volume or weight are required for the material to cure properly and develop full physical properties. Dispense Parts A and B proper proportions into clean plastic, metal or wax-free paper containers.

Adding Color - The EpoxAcoat® Epoxy Surface Coat System can be colored with SO Strong® color tints (from Smooth-On). Pre-mix tint with Part A thoroughly and then add Part B.

Mixing – Be sure mixing utensils are clean and free of any potential contaminants such as dirt, dust or grease. Mix Parts A and B thoroughly for at least 3 minutes with a square edged mixing stick. Be aggressive and scrape sides and bottom of mixing container several times.

Use the square edge of mixing stick to bring material off of the sides of container and blend. If using a drill mixer,follow with hand mixing as directed above to ensure thorough mixing. NOTE: Pot life can be extended by pouring mixture into a shallow pan, reducing its mass.

No customer reviews for the moment.

Write your review

Epocoat GREY -Gel Coat epoxi-

Epocoat GREY -Gel Coat epoxi-

Gel Coat Epoxy gray.
Thixotropic and high resistance to abrasion.
Ideal for FX molds and precision molds.

Write your review

Customers who bought this product also bought :

Epofer EX201 + E202

Epofer EX201...

13,20 €

PlatSil FS-10 -Silicona de Platino-


31,00 €

EASYPLAT 00-40 -Silicona de Platino para Moldes-


44,00 €

Ease-Demold 305 -Desmoldeante Líquido Universal-


12,00 €