Horario de atención y direcciones de las tiendas

Smooth-On

Ignite -Fluorescent Pigments-

Ignite -Fluorescent Pigments-

Fluorescent pigments for Polyurethane and Silicone
Pack of 9 colors to try them all
They glow under UV light

More details...

24,00 €

tax excl.

The Ignite® line of liquid fluorescent colorants is compatible with Smooth-On urethane rubbers, urethane plastics, urethane foams (rigid and flexible) and silicones. The fluorescent or "glow" effect is maximized under ultra-violet light or "black light." The most dramatic color effect is realized when an Ignite colorant is used with a clear or translucent urethane rubber (such as Clear Flex 50) or plastic (such as Smooth-Cast 325).

The Ignite® 9 pack gives you the opportunity to experience each color without spending a lot of money.

What Makes Castings Made With Ignite® Pigments Appear To Glow? When you add Ignite fluorescent color to a urethane material, more ultraviolet light from the cured material is visible to your eye vs. castings made with SO Strong® colorants. The casting appears brighter in ambient light and appears to glow under ultraviolet light.

ignite

To get you started, we offer the following colorant loading levels. Results may vary.

By Weight Using A Gram Scale: Add Ignite® colorant at a ratio of between 0.5% - 1.5% of the total weight (Parts A + B mixed) of the material being cast. 1% pigment yields the best results. Adding more than 1.5% by weight offers no benefit and is a waste of the colorant. Too much colorant may cause cure inhibition.

By Volume Measured In Drops: Add 30 drops of Ignite™ per 3 oz (88 ml) of mixed urethane material. If using a translucent material (like Smooth-Cast 325) you can use 15 drops to maintain translucency of the material.

Pre-Mix Before Using: Ignite® colorants are pigment dispersions and may separate over time. They must be thoroughly pre-mixed in the container before using with a liquid urethane product.

Directions For Use: After dispensing the required amount of urethane material Parts A and B into measuring containers, add colorant to Part B and mix thoroughly. Combine Parts A and B into a mixing container and mix as directed by the urethane product technical bulletin. Blending Colors - You can combine different colors on a pallete to create a custom color before adding to liquid urethane product as directed above.

Customers who bought this product also bought :

Curing agent 81

Curing agent 81

5,00 €

AC-1 Pure Acetone

AC-1 Pure...

2,50 €

PolarShine 35

PolarShine 35

20,00 €

Small rolling pin 40/06 Special for Polyester

Small...

2,50 €